Calcomp 1044 drivers11/19/2022 ![]() If switched to OFF, xplot stops immediately before plotting, waiting for a from the keyboard to continue. It can also be set by the rounding command. It can also be set by the bestfit command. If switched to ON, the driver automatically rotates the drawing to optimize the format on the sheet. ![]() Settings for these options may be overridden including specific xplot commands during a plotting session.ĭisable/enable the "busy" indicator during plotting (the default value is NO) Permitted values are: XON or HARD (the default is XON) Permitted values are E, O, N.ĭata bits (typically 8). ![]() Five entries are considered:īaud rate (typically 9600). OCE for Oce Graphics plotters and Benson plottersĬommunication parameters. The program checks this entry to be sure that the plotter matches the selected driver. To use an raster plotter the model must be 76xx compatible for HP plotters and 68xxxx compatible for Calcomp plotters. A list of available models is shown in Appendix E and F. If the mode is off-line to a file, no entry is required. If in spooled mode, then the spooler full pathname should be inserted here, between parenthesis (for example (/usr/bin/lp)). The plotter is connected, if operating in on-line mode. The name of the device file (/dev/.) to which In absence of this information, xplot will search the tabdef.dcf file for the first entry with type set accordingly to the driver envolked by the runmode Will be searched for in the TABDEF.DCF file. In this way it is possible to select any one of the defined output devices. starting with the option -plotter=PLOTTER ![]() using the PLOTTER environment variable, or Xplot can look for the label in two ways: The label must start in second column and be preceded by an * (asterisk) in firstĬolumn. Is a unique name that identifies the plotter model configuration. The line above refers to a HP 7475 plotter on-line on /dev/tty0. *PLOTHP=/dev/tty0 CLASS=PLOTTER MODEL=7475 TYPE=HP *PLOTHP=\\dellP200\laser5 CLASS=PLOTTER MODEL=7475 TYPE=HP Is a single line defining the plotter model currently usedīy xplot. Each plotter is defined by a set of configuration parameters: If your plotters comes from a different manufacturer, but can emulate one of these protocols, then treat it as if it were one of the three. The plotter section, described hereunder, contains information concerning three families of plotters: Two classes of devices are considered: plotters and digitisers. Usually this file is called tabdef.dcf, and resides in the directory addressed by the configuration file driverconfigfile entry. ![]() The device configuration file (extension DCF) contains information regarding peripheral devices that can be connected to Eagle. Plotting Appendix D - Device Configuration File entry format Appendix D - Device Configuration File entry format ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |